|
Supplied with 250ml Beaker, Teflon Assembly for holding capillary, Heater, RTD
Sensor, Silicon Oil, Melting Capillary one end sealed (Pack of 100 Nos), Boiling Tube,
Teflon Coated Magnetic Paddle, Power Cord, Operational & Instruction Manual.
Technical Specification :
- Temperature Range : 5ºC Above Ambient to 300ºC
- Heating before set point : Automatic Temperature Heating depending upon temp. diff.
- Heating after Set point : Variable 0.5, 1.0 & 2.0 ºC/min - Selectable
- Detection of Melting : Melting Range
- Temperature Resolution : 0.1ºC
- Calibration : Multipoint Point Calibration Standard - as per Pharmacopia or any users known standard.
- Melting Capillary : Three Capillary
- Sample : Borosilicate Capillary Tube One End Sealed
a) OD : 1.4 to 1.6 mm b) ID : 1.0mm c) Filling Height : 3 mm
- Temperature Sensor : PT-100
- Data Storage : Non Volatile Memory with more than 50 analysis data storage with corresponding calibration data.
- Method Storage : Ten User method parameter with Add/Edit Facility.
- Printer Output : Parallel Port (Optional)
- Keyboard : Alphanumeric Polyester Softkeys
- Backlit LCD Display : 20 x 4 Line Alphanumeric
- Power : 230 VAC ± 10%, 50Hz
Salient Features :
- Built in Magnetic Stirrer with soft touch Key Speed Controller with audio sound.
- Automatic Temperature Heating depending upon heating requirement.
- Electronic Temperature Regulator to increase / decrease heating rate.
- Facility to enter set temperature by using soft touch keypad.
- Soft Touch Keypad to prevent contact problem.
- Over heating protection by heater cut-off.
- On-site Temperature Calibration by Calibrated Thermometer / Calibration standards.
- Re-Call Default factory set calibrated temperature data.
Optional :
- Camera attachment
- Parallel Port for Dot matrix Printer attachment
- RS-232 to USB Interface with Cable & Driver Software to Transfer Data From Inst. to PC
|
